Laurel-electronics Ethernet Node Configuration for Series 2 Digital P Manual do Utilizador descarregar pdf (Página 10)

4. Connection of Transmitters

4.1 LTE Ethernet Transmitters

P1 Power input

3 Power GND

2 AC neut or -DC

AC high or +DC

P4 Analog

output (standard)

P3 Solid state

relays (normally

open, standard)

P5 Signal

input &

excitation

output

Ana out - 1

Ana out + 2

Alarm 2 1

Alarm 2 2

Aalrm 1 3

Alarm 1 4

Signal

conditioner

board

RJ45

P2 Ethernet

Reset

LTE Ethernet transmitters feature an RJ45 Ethernet connector, which allows the transmitter to be

connected directly to a computer, router, switch or hub via an Ethernet cable. The RJ45 connector

replaces the screws terminals that would otherwise be provided for RS485 or RS232 data I/O. An

isolated 4-20 mA, 0-20 mA or 0-10V analog output is standard, as are dual 120 mA solid state

relays for alarm or control. Signal conditioner boards are available for all popular industrial analog,

frequency and pulse-type transducer signals.

To reset the transmitter (same as power-up), press the Reset button.

To reset communications to 9600 baud, command mode, Custom ASCII protocol, and Address 1,

place a jumper at E1 and power up the transmitter.

Analog Output Jumpers

Current (0-20 mA) E2 a + d

Voltage (0-10V) E2 b + c

Excitation Output* Jumpers

5V, 100 mA E3 a + c; E4 a

10V, 120 mA E3 a + c; E4 b

24V, 50 mA E3 b, E4 none

* Attempting to draw more than the rated transducer excitation output current will shut down the

output.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Comentários a estes Manuais

Sem comentários

Laurel-electronics Ethernet Node Configuration for Series 2 Digital P Manual do Utilizador Página 10

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Laurel-electronics Ethernet Node Configuration for Series 2 Digital P